Step by step instructions to learn how to install pink batts snugfloor insulation detailed installation instruction for pink batts snugfloor https ww.
How to install insulation under floorboards.
Insulation down from the top of the battens i would suggest 75mm kingspan then cut sheets to required size in between joists and push in between joists onto the battens leaving the insulation level with top of the joists gun in any gap s with expanding foam then fit the board s.
First the robot enters the void through a small access hatch in the floorboards.
Now put your panels in place.
1 install strapping to support the glass wool floor insulation.
This will hold the insulation panels in place just below the top of the joist.
Underfloor insulation if you have you an access hatch that allows you to get into the crawlspace void below the floorboards this is a relatively easy process if not you will have to take up.
Place a bracket once every 600mm on both sides of every joist approximately 60mm below the top of the joist.
Lift up your floorboards and measure the spaces between your floor joists add a couple of centimeters to your measurement so that the rockwool will fit snug.
Next the robot sprays insulation foam to the underside of the floorboards.
Staple the strapping across the gap under your floor joists.
The insulation process is simple.
2 install the glass wool insulation in the floor.
Nail the brackets in lightly.
The robot travels through the void scanning and creating a 3d image of the under floor to ensure the property is suitable.
Install strapping to support the glass wool floor insulation.
Pull the strapping tight across the gap before stapling it in place.
Then use a panel offcut to confirm your brackets are in the right position before nailing them in fully.
Then using the insulation saw a knife or scissors may also work to providing they are sharp enough cut your rockwool to fit the gap.
Fit the rockwool into place.
This means if the floorboards have all been removed and you install from above the floor the printed blue side will face up towards the interior of the room.